Drylining and plastering

Drylining and plastering take-off from floor plans

For drylining and plastering contractors, QuantRead reads the floor plans and gives partition lengths, wall and ceiling areas less openings, and bead lengths, with the ceiling height it used shown on every line.

Try it free – 1 drawing, up to 3 pages

What QuantRead measures for drylining and plastering

  • Partition lengths (m), split by partition type where a key is shown
  • Wall area less openings, by room (m²)
  • Ceiling area by room (m²)
  • Angle and stop beads (m)
  • Doors and frames (nr) and skirting (m)

Profile in the app: “Plastering / drylining”. Every result also shows the scale used, how each line was measured, and a check-on-site list.

Heights make or break the area

Wall area is perimeter × ceiling height, less openings. If the plan or a section gives the height, QuantRead uses it. If not, it uses an assumed height and flags the line, because a wrong height quietly throws out every wall area on the job.

From m² to boards

A standard 2,400 × 1,200 mm board covers 2.88 m². Divide the area by 2.88, then multiply by the layers your system needs. See how to calculate plasterboard from drawings.

Worked example (illustrative)

A partition key shows 46 m of type A stud partition at 2.6 m high, boarded one layer each side, with 4 door openings of 0.9 × 2.1 m.

LineWorkingQty
Gross area, one side46 × 2.6119.6 m²
Less doors, one side4 × 0.9 × 2.17.56 m²
Net area, both sides(119.6 − 7.56) × 2224.08 m²
2.4 × 1.2 m boards before waste224.08 ÷ 2.8878 nr (77.8 rounded up)

Drylining and plastering take-off questions

Does it measure both faces of a partition?
It gives the partition length once. Multiply by faces and layers for your system, or ask for net wall area by room, which is per face.
Can it split by partition type?
Yes, if the drawing has a partition key such as types A, B and C.
What about suspended ceilings?
Ceiling area by room is measured. Grid type and bulkheads are for you to price from the specification.

Measure your next drylining and plastering job

Upload a PDF, pick your trade, and get an editable take-off with the scale used and a check-on-site list.

Try it free – 1 drawing, up to 3 pagesSee pricing

Used for drylining and plastering work across the UK

Who uses drylining and plastering take-off

Other trades

Drylining Take-Off: Partitions & Board m² | QuantRead