Groundworks and drainage
Groundworks and drainage take-off from site plans
From foundation and drainage layouts, QuantRead measures strip foundations, slabs, excavation areas and drainage runs, and counts manholes, chambers and gullies.
Try it free – 1 drawing, up to 3 pages
What QuantRead measures for groundworks and drainage
- Excavation and reduced-level areas (m²)
- Excavation volume, only where depths are shown (m³)
- Strip foundation lengths (m)
- Slab and hardstanding areas (m²)
- Drainage runs by diameter (m)
- Manholes, inspection chambers and gullies (nr)
- Kerbs and edgings (m)
Profile in the app: “Groundworks / Drainage”. Every result also shows the scale used, how each line was measured, and a check-on-site list.
Volumes only when depths are given
Excavation volume needs a depth. If the drawing gives one, it is used. If not, QuantRead gives the area and length only, rather than inventing a depth.
Worked example (illustrative)
| Line | Working | Qty |
|---|---|---|
| Strip foundation | centre-line length | 58.4 m |
| Excavation, 0.6 m wide × 1.0 m deep | 58.4 × 0.6 × 1.0 | 35.04 m³ |
| 100 mm foul drainage | drawn runs | 42.0 m |
| Inspection chambers | counted | 5 nr |
Groundworks and drainage take-off questions
- Does it allow for bulking?
- No. Volumes are solid, in-the-ground volumes. Apply your own bulking factor for muck away.
- Can it read invert levels?
- It reads levels written on the drawing and uses them where it can, flagging the rest.
- Is it suitable for civils?
- It suits building groundworks and drainage. Large civils jobs with earthworks models need specialist software.
Measure your next groundworks and drainage job
Upload a PDF, pick your trade, and get an editable take-off with the scale used and a check-on-site list.
Used for groundworks and drainage work across the UK
- Groundworks and drainage take-off in Sheffield
- Groundworks and drainage take-off in Peterborough
- Groundworks and drainage take-off in Hull
- Groundworks and drainage take-off in Sunderland